Last Edited by Alucard400
September 8, 2019
Make sure to flash the "bleemsync kernel" in order to use two controllers, and a thumb drive for games!! You'll need a cheap otg cable, but it works great!! Once you flash the bleemsync kernel, you are free to use either bleemsync, or autobleem with otg support!!!
1. To Enable usb hub support on rear micro USB port using BleemSync.
extract BleemSync1.X version
to flash drive (make sure to property format drive to Fat32 with EaseUS Partition)
put flashdrive to ps classic usb controller port 2. plug power and hdmi to ps classic. wait for orange light. push power.
let the utility make a copy of the kernel on the ps classic. takes 2 minutes. once done, the system will restart (5 in secs message).
Light will turn orange again while being off. unplug power cable, unplug flashdrive.
Plug flashdrive to PC. copy backup folder from the bleemsync folder to your PC. this is the Kernel to back up.
On the flashdrive. go to the update folder. it is empty
copy LBOOT.EPB into this folder
eject the flashdrive.
Plug into the PS classic (make sure power plug is not on ps classic).
attach ac power plug on ps classic. wait for orange. then push POWER.
Allow the system to configure. once done, it will turn off. wait for orange light. unplug power cord. unplug flash drive.
Now plug in hub/adapter on rear port of PS Classic. attach your pre built Autobleem flashdrive full of games on the rear usb socket adapter. attach power plug on rear adapter also. Turn on and enjoy.