Thread DetailsLast Edited by widgit September 23, 2016 at 08:34 PM
This ingenious screw design replaces the milspec factory grip screw to remove the trigger creep and travel from factory mil-spec triggers in the AR15 rifle. The kit comes with one(1) grip screw with an internal adjustment screw, one (1) lock washer, one (1) reduced power hammer spring and one (1) hex wrench for adjustment of the internal screw. The adjustment screw allows for tweaking the hammer and trigger engagement points to clean up the GI trigger and give you a cleaner trigger pull for increased accuracy. The reduced power hammer spring reduces the trigger weight for a lighter pull.
Application: The Reduced Power Hammer Spring is intended for competition and recreational use only and should not be installed in any rifle used for defense or duty applications. By reducing the spring tension, the introduction of light strikes or failures to fire due to the lack of primer detonation may occur in some ammunition.