frontpage Posted by MG_LIFE • 11h ago
Jul 9, 2025 10:52 AM
Item 1 of 10
Item 1 of 10
frontpage Posted by MG_LIFE • 11h ago
Jul 9, 2025 10:52 AM
Soleyin by Creality 1kg Spool 1.75mm Ultra PLA 3D Printer Filament (Black)
+ Free S/H6 for $33
$60
Amazon
Get Deal at AmazonGood Deal
Bad Deal
Save
Share
Leave a Comment
Top Comments
No amount of drying, settings, or tweaks made it decent. I tried 5x of the rolls thinking maybe it was just bad luck with the first one or two and gave up and tossed it all.
Stick with Sunlu, Elegoo, Polynaker, etc.
There is a reason this stuff is so cheap, ALL the time.
44 Comments
Sign up for a Slickdeals account to remove this ad.
Do I now have 5 more on the way? Also yes.
Our community has rated this post as helpful. If you agree, why not thank Gator8888
Sign up for a Slickdeals account to remove this ad.
Our community has rated this post as helpful. If you agree, why not thank blueapplepaste
This filament sucks. I bought 10x rolls on a previous deal and ended up trashing it all.
No amount of drying, settings, or tweaks made it decent. I tried 5x of the rolls thinking maybe it was just bad luck with the first one or two and gave up and tossed it all.
Stick with Sunlu, Elegoo, Polynaker, etc.
No amount of drying, settings, or tweaks made it decent. I tried 5x of the rolls thinking maybe it was just bad luck with the first one or two and gave up and tossed it all.
Stick with Sunlu, Elegoo, Polynaker, etc.
There was a bad batch that had humidity in it before the vacuum seal. All that stuff you threw out would've worked fine if you had it filiament drier, and dried the filament right after taking out of the vacuum sealed packaging.
I believe all those bad batches are gone . The latest ones I got did not have any problem printing. My theory is the spools and the factory were left in a store too long before being vacuum sealed into plastic so they got a bunch of humidity in them before being sealed.
I can't remember off the top of my head if this one requires lower speed settings.
It is a filament I'm more fond of though I like the colors I like how they printed .
If you wanna go premium motor filament dryer , get a roomie toaster oven with a dehydrator function, or any function that will go down to 120F. There's lots of toaster ovens that fit his profile on Slickdeals. That is the way. You have to download the manual make sure it'll load enough temperature. About 2/3 of the slick ovens do not have dehydrator function. So you have to get the Slickdeals oven that does have a function.
Sign up for a Slickdeals account to remove this ad.
Our community has rated this post as helpful. If you agree, why not thank PopoSheeSho
Ridiculously fragile. Often over-adheres to plates. Horrible layer adhesion if used with any other PLA for Multi-Color prints. Do not recommend. I had 10 different colors & they all acted the same, after running through typical Orca Slicer calibration.
There is a reason this stuff is so cheap, ALL the time.
Leave a Comment