expiredTattyBear | Staff posted Jan 17, 2023 08:32 PM
Item 1 of 4
Item 1 of 4
expiredTattyBear | Staff posted Jan 17, 2023 08:32 PM
2-Pack UST Ultimate Survival Technologies Watertight Fire Kit
+ Free Shipping$10
$20
50% offField Supply
Visit Field SupplyGood Deal
Bad Deal
Save
Share
Leave a Comment
Top Comments
Squeeze as much petroleum jelly into each one.
Shove them in a spare pill bottle til it's full of Vaseline filled cotton balls.
Wrap a Bic lighter in plastic wrap and tape it a bit to keep it wrapped up.
Now put that pill bottle of cotton balls, and the Bic lighter in a zip loc bag.
The real slick deal.
38 Comments
Sign up for a Slickdeals account to remove this ad.
I would not trust the case to keep water out. It needs a thicker oring or a tighter clamp. I would also worry about the case breaking when in a bag with other gear.
Good for a drawer in the house.
But, this has inspired me to print my own
EDIT: I kept one of them slightly underwater for an hour or so. About 5 drops of water were on the inside. So, it's not 100% waterproof, but then again, hopefully you, or it, won't be under water for an hour plus. I was debating performing a crush test. I might do that after I print a new housing.
One came broken. Good enough to leave one in the jeep and one in the ATV. Sparker will work wet or dry
I would not trust the case to keep water out. It needs a thicker oring or a tighter clamp. I would also worry about the case breaking when in a bag with other gear.
Good for a drawer in the house.
But, this has inspired me to print my own ������
EDIT: I kept one of them slightly underwater for an hour or so. About 5 drops of water were on the inside. So, it's not 100% waterproof, but then again, hopefully you, or it, won't be under water for an hour plus. I was debating performing a crush test. I might do that after I print a new housing.
I would not trust the case to keep water out. It needs a thicker oring or a tighter clamp. I would also worry about the case breaking when in a bag with other gear.
Good for a drawer in the house.
But, this has inspired me to print my own
EDIT: I kept one of them slightly underwater for an hour or so. About 5 drops of water were on the inside. So, it's not 100% waterproof, but then again, hopefully you, or it, won't be under water for an hour plus. I was debating performing a crush test. I might do that after I print a new housing.
The instructions state to expand the tinder by ripping it apart with your fingers but it's nice to have a knife to assist with that task.
pics: https://imgur.com/a/qDCvMvw
My only complaint is the clasp is cheap and will surely break at some point. but it's a $5 dry box so you can't expect much.
Sign up for a Slickdeals account to remove this ad.
Leave a Comment