Y Branch Parallel Connector: 1 male to 2 female and 1 female to 2 male solar connectors can connect two solar panels in parallel to provide greater power usage
Wide Application: The solar Y connector is made of PPO and tinned copper and is compatible with various solar cables: 14-10 AWG (1.5 mm² - 6 mm²)
IP68 Waterproof: Better waterproof and dustproof performance than IP67, VL94-V0 flame retardant grade, working temperature -49 ℉-194 ℉, which can work normally in harsh environments
Plug and Play: The solar Y branch is connected by pressing and unlocked by pressing the buckles on both sides, and will not slip off easily
Technical Specification: Solar cable rated current: 30 A, rated voltage: DC 1000 V; Suitable for most solar systems
https://www.amazon.com/dp/B01M7RQ...gToDp&th=1
Leave a Comment
7 Comments
Sign up for a Slickdeals account to remove this ad.
Best, maybe mandatory, that all panels interconnected are the same design/ratings.
It's that fleeting thought after a large DIY project- connecting Frankenstein for the first time.
More like a possible burn up. Not all MC4-compatible connectors are ... compatible with each other. Checking forums (and the occasional transparent tech support of manufacturers) for horror stories might identify all the incompatible combinations. Then all's left is the luck in quality control of the prebuilt (or diy) crimp and connector body. Perhaps a (4-wire) mili-ohm meter reading- before/after a few disconnect cycles is a bit overkill, but depends on the power it's pumping and if the panels are on a very old shake roof. Contact resistance = fire.
In for 4, thanks!
Leave a Comment