Update: This very popular Frontpage Deal is still available.
Bestergo Direct via Amazon has
Perlegear Ultra Slim 1.1" Low Profile TV Wall Mount for 42-90" TVs (PGTVM65B-LF-US) on sale for $69.98 - $30.09 with promo code
01NEBXKZ at checkout =
$39.89.
Shipping is free.
Thanks to Staff Member
DesertGardener for sharing this deal.
- Note: You must be logged in to clip coupons or apply promo codes. Coupons/Promo codes may vary by account or may need to be re-applied in order to discount properly.
Details:
- Fits 42–90 in LCD/LED/OLED TVs; VESA 200×200 to 600×400 mm; 132 lb capacity
- Extendable wall plate for 16–24 in wood studs, concrete, or brick; do not mount on drywall alone
- 1.1 in flush; extends to 15 in; tilt +5° / −15°; swivel ±45°; post-install level ±3°
- Steel; stated 4× max-load test
- Includes instructions, bubble level, drilling template, and pre-labeled hardware; US-based support listed
Join The Conversation
Share your experience with the Slickdeals community
Share information with the community. Please follow our Community Guidelines and be kind!
20 Comments
Sign up for a Slickdeals account to remove this ad.
You're very welcome
Our community has rated this post as helpful. If you agree, why not thank
Or the LG OLED77CXAUA?
Or the LG OLED77CXAUA?
Sign up for a Slickdeals account to remove this ad.
Sign up for a Slickdeals account to remove this ad.
Annoyance that the bolt head was a bigger size than other sets I've used in the past, and I actually didn't have the bit so I can use my drill, had to muscle in using a ratchet. Oh and the bolt shank is a little bigger, too, and even good sets of drill bits don't go in 16ths so using the next smaller bit made it even more annoying.
More serious, the design is such that the bracket for the 24 inch studs doesn't sit on the wall, probably 1/8 inch off on each side, so bolting it to the wall is weird and you never clamp the bracket onto the wall itself, it just hangs out in mid air.
Worst of all, the template included is not accurate between the top and bottom, so your holes won't line up. Then, you'll either have to move it altogether and do new holes a different way, or what I did, shove chopsticks in the hole and send it because I'm only hanging a 65".
If you get this, just do the top holes with the template and use the actual bracket mounted to draw where you need to do the bottom holes.
Join The Conversation
Share your experience with the Slickdeals community
Share information with the community. Please follow our Community Guidelines and be kind!