Micro Center Stores [
store locator] offer
New Customers: Creality Ender 3 Pro 3D Printer for
$99.99 when you follow the steps below and present unique text coupon barcode at pickup. Offer valid in-store only.
Thanks to community member
CoralSnow2254 for finding this deal.
Deal Instructions:
- Visit the Sign-up Page here and fill out your info
- Click on the Send My Coupon button
- Wait for the page to load, this can take some time
- Note: If it errors-out, reload the page and try again
- Once completed you will get a 'Thank you, your coupon code has been sent.' message on the page
- Check your Text Messages and reply Y to the text that was sent
- You should receive a link to your Coupon shortly after
Top Comments
https://www.microcenter
Based on threads from past deals, some people have issues getting a coupon using a VoIP number and I believe with Mint wireless as well.
Also there usually is a $10 coupon inside the box for Inland filament. The Inland filament is around $20 so it's a pretty good deal. The box does come with a little bit of filament to print out a few samples but it's a good idea to pickup a roll to get started.
This is a very mod friendly printer with a large community. Some people will shit on the printer but if you're just starting out you can't beat a $100 printer that has very decent print quality. If you wanted, you can upgrade a lot of the components and make the print quality even better. This doesn't come with a silent board, just FYI.
The plate was very hard to level completely. Mine had a high spot. Glass bed was only slightly better. The z axis sags. You can upgrade to dual z motor. The firmware doesn't support pausing (to change colors or add magnets), you can update it (which isn't hard but not simple).
I ended up buying a anycubic vyper which is very similar to this printer but with all of the upgrades on it already ($300). I'm going to just sell my ender and I'm guessing I can get my $100 back on FB.
It's not a bad printer, but it'll never really be plug and play. After every few prints, something will end up needing calibration and it's a lot of time trying to figure out what/why/how
107 Comments
Sign up for a Slickdeals account to remove this ad.
https://www.microcenter
Based on threads from past deals, some people have issues getting a coupon using a VoIP number and I believe with Mint wireless as well.
Also there usually is a $10 coupon inside the box for Inland filament. The Inland filament is around $20 so it's a pretty good deal. The box does come with a little bit of filament to print out a few samples but it's a good idea to pickup a roll to get started.
This is a very mod friendly printer with a large community. Some people will shit on the printer but if you're just starting out you can't beat a $100 printer that has very decent print quality. If you wanted, you can upgrade a lot of the components and make the print quality even better. This doesn't come with a silent board, just FYI.
or while supplies last!
or while supplies last!