popularaepro | Staff posted Today 03:18 PM
Item 1 of 1
popularaepro | Staff posted Today 03:18 PM
Sovol SV08 Core-XY 3D Printer $425 + Free Shipping $424.92
$425
AliExpress
Get Deal at AliExpressGood Deal
Bad Deal
Save
Share
Deal Details
Sovol Store via AliExpress [aliexpress.us] has Sovol SV08 Core-XY 3D Printer Open Source, Max 700mm/s High Speed 3D Printers with 300℃ Clog-free Hotend and Camera on sale for $424.92 w/ code USDEAL60. Shipping is free.
Ships from the US.
Ships from the US.
Community Notes
About the Poster
Deal Details
Community Notes
About the Poster
Sovol Store via AliExpress [aliexpress.us] has Sovol SV08 Core-XY 3D Printer Open Source, Max 700mm/s High Speed 3D Printers with 300℃ Clog-free Hotend and Camera on sale for $424.92 w/ code USDEAL60. Shipping is free.
Ships from the US.
Ships from the US.
Community Voting
Deal Score
+5
Good Deal
Bad Deal
Found by Rokket
Forum Thread
51% off
There is no voting data on this thread
Found by minntwins
Forum Thread
44% off
There is no voting data on this thread
Found by htp182
Forum Thread
70% off
There is no voting data on this thread
Found by Immortalsolitude
Forum Thread
24% off
There is no voting data on this thread
Found by phoinix
Forum Thread
51% off
There is no voting data on this thread
Found by Dr.W
Forum Thread
38% off
There is no voting data on this thread
Found by gaamn114
Forum Thread
27% off
There is no voting data on this thread
Found by iconian
Forum Thread
35% off
There is no voting data on this thread
Found by Dr.W
Forum Thread
44% off
There is no voting data on this thread
Found by NeedMoCoffee
Forum Thread
60% off
There is no voting data on this thread
Leave a Comment
2 Comments
Sign up for a Slickdeals account to remove this ad.
I had issues with bed leveling from the start. I switched to an eddy current sensor for bed leveling. That was an ordeal to get functioning but that was partially my fault for flashing the wrong firmware. I still run into an occasional nozzle bed crash on calibration at the beginning of a print. The eddy sensor is significantly faster for measuring the bed plate though.
These printers are notorious for having "taco" shaped print beds. Larger prints require pre-heating the bed for 20-30 minutes for the bed to settle into its heated shape. There are some guides to help flatten it out there. I generally only run into issues if I have a large print that goes into around 20mm of each corner. I've had the nozzle drag there on a few occasions.
If you don't mind some tinkering, it is a great printer for larger format prints. This is my first klipper based printer and I definitely prefer it.
It can print rather fast but I'd slow it down for typical printing as quality suffers from the speed.
Leave a Comment