After changing heatsink core 0 at 16 and core#1 at 31
Expired
Thread created 09-23-2012 by ask_j
0 Score
10 Replies
660 Views
That would make it......roughly 61* Farenheit. I *could* see that being the case, with fans blowing air across it. Could that core completely shut itself down if not being used? Though one would...
After changing heatsink core 0 at 16 and core#1 at 31
Expired
Thread created 09-23-2012 by ask_j
0 Score
10 Replies
660 Views
Hi,
I have Abit ip35 Pro with E8400. I had the original heatsink and now changed to Hyper 212 EVO. Both of my cores have very different temperatures. One has 16 degree and other one at 32...
After changing heatsink core 0 at 16 and core#1 at 31
Expired
Thread created 09-23-2012 by ask_j
0 Score
10 Replies
660 Views
hey so i'm not the only person with an ip35 pro! It died last week tho.... :(
After changing heatsink core 0 at 16 and core#1 at 31
Expired
Thread created 09-23-2012 by ask_j
0 Score
10 Replies
660 Views
Mine is still working:)..
I have used core temp and HWiNFO64. I did the reinstall of heatsink again. Still same result.
I have attached the image from the HWiNFO64..
After changing heatsink core 0 at 16 and core#1 at 31
Expired
Thread created 09-23-2012 by ask_j
0 Score
10 Replies
660 Views
The temperature reading is wrong. 16C reading is too low for any processor unless the machine's ambient temperature is nearly freezing.
Get other temperature monitoring tools as well as check the...
After changing heatsink core 0 at 16 and core#1 at 31
Expired
Thread created 09-23-2012 by ask_j
0 Score
10 Replies
660 Views
try to use core temp software http://www.alcpu.com/CoreTemp/
After changing heatsink core 0 at 16 and core#1 at 31
Expired
Thread created 09-23-2012 by ask_j
0 Score
10 Replies
660 Views
I cleaned the old thermal both the times, and before I re installed I checked the thermal paste was correctly installed. Then I removed that thermal paste and put new one.
It looks weird that both...
After changing heatsink core 0 at 16 and core#1 at 31
Expired
Thread created 09-23-2012 by ask_j
0 Score
10 Replies
660 Views
I still can't see it being that low, the room temperature would need to be under that, and even then, the two cores are half an inch apart and connected by a copper heatsink
After changing heatsink core 0 at 16 and core#1 at 31
Expired
Thread created 09-23-2012 by ask_j
0 Score
10 Replies
660 Views
Core temperature is also showing same results..
After changing heatsink core 0 at 16 and core#1 at 31
Expired
Thread created 09-23-2012 by ask_j
0 Score
10 Replies
660 Views
Did you clean off the old thermal paste and reapply new when you did this? I am guessing you might have a large air bubble.
After changing heatsink core 0 at 16 and core#1 at 31
Expired
Thread created 09-23-2012 by ask_j
0 Score
10 Replies
660 Views
Application methodology could skew results too, rice grain vs thin layer methods.
OP, have you looked into core usage? Maybe your system is pegging one core more than the other resulting in the...
