expiredsuihuamo posted Today 04:25 PM
Item 1 of 2
Item 1 of 2
expiredsuihuamo posted Today 04:25 PM
BIQU CryoGrip Panda Build Plate for Bambu-lab X1C X1E P1S P1P A1, Room Temp Cold Printing, Double-Sided Textured Spring Steel Sheet, 257x257mm, 1 Piece, Grey $15.59
$16
$26
38% offAmazon
Visit AmazonGood Deal
Bad Deal
Save
Share
Leave a Comment
10 Comments
Sign up for a Slickdeals account to remove this ad.
Also, I have the printer in the same room where I work, so using this plate helps me keep the room cooler. So this has basically become my summertime build plate unless I'm looking for specific textures on the bottom surface.
Also, I have the printer in the same room where I work, so using this plate helps me keep the room cooler. So this has basically become my summertime build plate unless I'm looking for specific textures on the bottom surface.
And having said that, I do run some prints with no heating but it's not as reliable a result as using some heat.
Sign up for a Slickdeals account to remove this ad.
Whats the difference between this one and the pro versions frostbite and glacier?
Frostbite has the best adhesion of the 3, sometimes too good which is why you may not always just use that one vs the one in this OP. Vs the one in this OP, the frostbite can print at Ambient temps while I find the one in this OP needs a drop of heat, but not much. The galicier is the smoothest of the three with the least adhesion (which I sometimes want). Depending on what your printing, the surface of the glacier will have a nicer finish on the bottom. I personally have uses for all three plates.
Leave a Comment