Don't have Amazon Prime? Students can get a
free 6-Month Amazon Prime trial with free 2-day shipping, unlimited video streaming & more.
If you're not a student, there's also a
free 1-Month Amazon Prime trial available.
You can also earn cash back rewards on Amazon and Whole Foods purchases with the
Amazon Prime Visa credit card. Read our review to see if itās the right card for you.
28 Comments
Your comment cannot be blank.
Featured Comments
https://www.youtube.com/watch?v=NutwD7B
Sign up for a Slickdeals account to remove this ad.
Was looking for such blade set for my 7480, when checkout it automatically apply the $10 credit of GC Gift For PD21.
Read your owner's manual, because I am betting all liability for using any dado set is on you. If you have a thread or two after mounted, I would use it. Just make sure on any saw that the thinner blade is on top of the threads, or you will not get a flat bottom cut.
PS: Although the common 5/8" arbor, you may have to make or buy a different throat plate for blade clearance.
=========
Before dado sets and as long as the teeth were offset to not touch, my Grandfather stacked regular saw blades with a flat rake tooth for a square bottom. Seemed to work just fine with the only limitation being the length of the saw's arbor.
The OP set has a 20 degree positive rake, so if using with a radial, you want to push into material and not pull.
Sign up for a Slickdeals account to remove this ad.
====================
Years ago and before stacked sets, the dado sets that came out to fit most saws that had shorter shafts, were the somewhat balanced wobble dado blade example [amazon.com] that are still sold and economical in comparison to stacked sets. There are better models than that example, but I am not chasing it down. My Dad used one for years in his home shop and worked fine. I always thought they would be a little hard on the bearings in a commercial shop, but the goods ones did not have the expected vibration.
As for the throat plate discussion, the 1/4" kerf fit into my DW745 but the 3/8" kerf did not. The throat opening was more than 3/8" wide but the arbor position was offset a bit. My suggestion is to just make a throat plate. A bit of a distraction but you can make one in about 30 minutes.
Our community has rated this post as helpful. If you agree, why not thank NotReal
https://www.youtube.com/watch?v=NutwD7B